|
Instructions on how to unlock your phone using the Any Network device
1. Insert the simcard you want to use on your iPhone 3G into another phone and make a call to ensure your simcard is working, this will enable your sim to receive some data from your network which is required for the Any-Network device. Any Pin Lock or Sim Code must be removed.
2. Now take out simcard from this phone.
3.Take your iPhone 3G and disable 3G and put in the Any-Network device along with this simcard in your iPhone 3G. Swipe the unlock and a message will appear on screen 'this unlock card is ok to use'.
Your phone should pick up the network within 3 - 5 minutes. (If it doesn’t find the network, please try to switch off your iPhone for 5 minutes and retry the whole process. )
Now you can use your iPhone 3G as if it was unlocked. You can now use EDGE, GPRS and all functions of iPhone 3G.
3G service depends on the type of simcard you have and it also depends on the availability of 3G network in your area. Please ensure you enter the APN settings for your carrier.
All those countries where there is no 3G, users are advised to switch off 3G mode.
Please note :
You must make sure that your iPhone is activated first. You can do this using the simcard which was provided when you purchased the iPhone or if you do not have a simcard just follow this guide .
You should not skip step1 listed above as data is needed from the network for our device to work. If in future you lose a signal just run these steps again to update the data.
|